Panel Construction - Panel D
[ ] Cut a 5” long piece from the 14” pieces for CONTROL PANEL D.
With your TV still in place, test fit PANEL D to figure out if it will need to be trimmed down from 5”. The top face of PANEL D should be parallel to the angle of the cabinet and at the same level (about 1/16” down) from the edge. PANEL C and PANEL D should meet like the plans show.
[ ] Attach mounting blocks and translate the location of the blocks to the side panels for screwing it down later.
[ ] Once you have PANEL D cut to size, map out where your controls will be mounted and drill the holes for them.
With your TV still in place, test fit PANEL D to figure out if it will need to be trimmed down from 5”. The top face of PANEL D should be parallel to the angle of the cabinet and at the same level (about 1/16” down) from the edge. PANEL C and PANEL D should meet like the plans show.
[ ] Attach mounting blocks and translate the location of the blocks to the side panels for screwing it down later.
[ ] Once you have PANEL D cut to size, map out where your controls will be mounted and drill the holes for them.
Next: Speaker Panel
posted by Tricky at 8:57 PM
Permanent Link
0 Comments
Post a Comment
Links to this post:
Create a Link
<< Home